
Experimental analysis of wheel and bogie frame transfer functions for on-board measurements of rail roughness
Acceleration measurements on in-service rail vehicles give many valuable insights into track condition. These measurements are favourable in terms of measurement frequency, no need for additional track possession for measurements, operator safety, etc. The collected acceleration data
however needs to be further processed to extract more detailed information on rail surface defects. To derive rail roughness from bogie frame acceleration, a complex signal processing approach is required, as well as determining the dynamic parameters of the track, vehicle, and operational
conditions. In this paper, a method to evaluate the influence of resilient wheel and bogie frame on the acceleration data received from bogie frame-mounted accelerometers is described. The method is based on a standstill measurement of frequency response functions on wheel and bogie frame
positions using an impact hammer and accelerometers. Following the preliminary results of bogie acceleration measurements, in-situ wheel receptance measurements were carried out on the same tramway vehicle in a standstill position, to determine the transfer function between the wheel-rail
contact point and the position of the accelerometer mounted on the wheel frame. After the experimental study, a discussion of their potential application in the method for deriving rail roughness from vibration data is presented.
The requested document is freely available to subscribers. Users without a subscription can purchase this article.
- Sign in below if you have already registered for online access
Sign in
Document Type: Research Article
Affiliations: Faculty of Civil Engineering, University of Zagreb, Croatia
Publication date: 04 October 2024
- Access Key
- Free content
- Partial Free content
- New content
- Open access content
- Partial Open access content
- Subscribed content
- Partial Subscribed content
- Free trial content